Questions & Answers for: Geo cylinder miss

bad miss car has bad miss. like a dead cylinder. replaced disttributor cap, rotor. plugs and wires soif you want to do this car at batter than its a time to develop your skiils & try it for yours

...on no.3 inspect the engine for arching from ignition wire to the engine ground on number three cylinder listen for a zapping sound . turn engine off and make sure the wire connections are solid ...

...up hills to. Do you know what it might be Put a vacume gauge on it, bet the miss is still there. Are you getting a check engine light? Possible bad cylinder or a head gasket. Any water in the

engine misses blows water out the overflow in radiator Sounds like you are blowing a cylinder into the cooling system. Could be a head gasget Could be a cracket water jacket. Do a compression test to ...

cylinder.If the miss is not narrowed down to one,or two cylinders,then run a compression test on all the cylinders,if while testing one cylinder,and the gauge fluctuates up and down,then check the one

one cylinder is missing pulled wire off of the one we thought it was and did not change, so we replaced the injector and did same thing! Just wondering if it is computer related? The question would be

...cylinder that plug came from to help you locate the miss. I'm assuming you have throttle body injection? G16A 1.6L 8valve TBI engine misfire. The order is ( tune up it , cap ,rotor, wires, sparks) ...

miss firing on #1 cylinder .lots of white smoke replaced injector.no change .170lb. compression on all cylinders.unplug injector not so much smoke. at times miss firing on one cylinder is caused by ...

...dont need my a/c. I need just my heater an defroster the metro works just like the sidekick, less 1 cylinder. does engine reach 180F coolant temperature and hold? 2 causes, and 8 ways to ...

...disconnect the spark plug wires one at a time. As the wire is disconnected, the engine should start to miss. If there is no change, then that is the bad cylinder. Could be bad wire, or engine