Questions & Answers for: Cadillac Catera where is cylinder 2

...Cylinder 2 misfire detected Repairing a 97 Catera and its giving a code P0302 which is cylinder 2 misfire detected. I have replaced the #2 spark plug which on this motor is on the front drivers side ...

...it may just work for you. That is what the locksmith told me. He quickly cut me 2 keys. However, the ignition cylinder was so worn that he then replaced the wafers (tumblers). He only charged me

...engine #2 cylinder is the second one from the front of the engine (distribuition side), if its a v6 engine #2 cylinder is the front one (distribuition side) on the left hand cylinder head. take

...will make the engine run: 1. Fuel, 2. Spark, 3. Compression. 1. Check you are getting fuel to the cylinders, you should hear a motor sound in the fuel tank when key is cycled on and off. Check for ...

for a 1998 cadillac catera 3.0 For the 1998 Cadillac Catera 3.0L DOHC V6: Firing Order: 1-2-3-4-5-6 Cylinders: ........(back)........ |...5...|.......|...6...| |...3...|.......|...4...| |...1...|.....

...2 crankshaft sensors are located on the front of the engine block, between cylinder Numbers 4 and 6. Crankshaft position A sensor is located on the upper crankcase and crankshaft position B sensor is ...

...cables into a distributor of a cadillac catera 1997? STANDING IN FRONT OF ENGINE FACING CRANKSHAFT.CYLINDERS ON LEFT SIDE ENGINE 1 3 5 AND CYLINDERS ON THE RIGHT SIDE OF THE ENGINE ON DRIVER SIDE IS ...

...2 rubber hoses on the top of the engine The hoses are crank case breathers on the engine side should be a pcv valve remove and shake it if it rattles it is still good,  there should be a small ...

...2) All 4 oxygen sensors were recently replaced. The spark plug for cylinder 5 was broken and all spark plugs were recently replaced. I did have oil leaked into the cylinders before and the gasket was ...

...rail and lower intake.also you have to remove timing cover and camshaft sprockets.you have to remove rear timing cover the thermostat housing between both cylinder blocks.you looking at 2 hour