Questions & Answers for: Mitsubishi Lancer where is cylinder 1

cylinder and put the car on the odb reader again it should change location of misfire .. then that would tell you that its the ignition coil thats bad i ended up getting my coil at the dealer for $110

Ad

Lancer The 4G63 (2.0L) engine is an in-line four-cylinder engine. The cylinder numbers are assigned as 1-2-3-4 from the front of the engine (timing belt side). This engine.s firing order is 1, 3, 4, 2

Ad

...Cylinder 1 Misfire the plugs and wires are new....any other possible solutions? Two things to check: Had the same type of issue on my Mustang. 1. The coil might be bad. 2. Is the plug getting wet? If ...

Question about 2003 Lancer

1 Answer

...cylinder 1 misfire.Check cylinder 1 and replace the faulty cylinder 1 to clear the fault.The spark plugs and the wires connecting to spark plugs also needs to be checked. Keep updated with any more ...

Question about 2003 Lancer

1 Answer

cylinder 1 (far passenger side) to top dead center. There is a mark on the block you can see just behind the crankshaft gear that needs to be aligned to the mark on the crankshaft gear. CAUTION NOT TO

Question about 2003 Lancer

1 Answer

1 per cylinder and theres often 2 cylinders per wheel. Try to de-adjust the wheel cylinders to free the wheel. This wil only allow the wheel to turn. After a brake aplication u might find the wheel is

...cylinder 2 and 3 2 and 3 use the same coil, correct? Try swapping that coil with the 1/4 coil. If the coil still doesn't work and the 1/4 coil now has spark for the 2/3 cylinders than the coil is ...

Question about 2005 Lancer

1 Answer

...Front of the engine is where the belts are located, #1 is the front cylinder closest to the belts. Followed by 2, 3, and 4. So the #2 cylinder is the second one back from the front of the

cylinder at the front of the engine is #1. Followed by #'s 2, 3, and 4 all in order. The firing order is 1-3-4-2, but that is only the order that they fire in, not there location. So #2 is the 2nd

...1. Are there any cracks in the cylinder head. This must be tested, 2. Are there any cracks in the engine block. This must be checked. Less likely than in the cylinder head but also possible when the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...