...1 cylinder to where piston is up, and on the compression stroke (TDC). Easiest way to do this is with a compression tester on the #1 cylinder - rotor cap OFF. When you see the pressure build...you're ...
...1 cylinder TDC and remove the distubuter cap. Place a mark on the body of the distributer inline with the rotor point before you do anything else. This mark may already be there, but if not, it needs ...
...1 cylinder.point the light at the timing marks and adjust the timing to spec.when the timing is set tighten distributor hold down bolt and recheck timing to make sure tightening the bolt hasn`t ...
Question about 1993 Roadmaster
...Check valve timing make sure that when #1 cylinder is firing the piston is at TDC.> Chech for vacuum leaks > check for exaust back pressure (plugged catalytic converter)>good ...
...cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The ...
Usually answered in minutes!
335 Questions
186 Questions
155 Questions
158 Questions
156 Questions