...crown vic 4.6 litr idles over 1500 rpm on start up for about 15-30 seconds than drops down to 900 rpms. car has 18,000 miles and is in otherwise great shape. What could it be? This sounds like a ...
what is the fuel pressure for 89 Ford Crown Vic with 5.0. Idle and blipped throttle 34-45 psi. for EFI. No seperate pressures between idle and WOT.
...crown vic, was diagnosed with a faulty idle control sensor. Where is it located and how hard is it to replace? Thanks if it was called an idle air control solenoid, then no it isn't hard to change. ...
starts fine in summer/dosent in winter/takes 2-3 cranks before it holds idle . 99 crown vic perhaps you have a sticking IAC valve. Idle Air Control valve. pretty common concern.
what do this car code mean dtc 411 on a 1993 ford crown victoria according to the computer its a Idle speed system not controlling idle properly (generally idle too high) - ISC
Question about 1988 Crown Victoria
...crown vic where is the idle air control valve located on a 1988 crown vic with a 5.0 liter fuel injected motor attached to the throttle body,looks like an electric motor bolted to a square piece with ...
...Crown Victoria. Engine revs up and then gutters out. will die at stop light and if left idleing. Checked vacuum hoses and all are fine. what else can I check? No guarantees without inspecting it but ...
my 1997 crown victoria's idle is too low and it needs to be adjusted. i was wondering how to do that. there is no adjustment, the IAC (idle Air Control) is a common failure, so replace it.
...Crown Vic. Will crank, but will not idle.Have to keep foot on gas. have a 97 crown vic, in warm weather it idles fine and run fine now that its cold I have to hold at high idle to have warm up for ...
My 1985 crown vic idles too high, how can I adjust it? You can't adjust it, it is controlled automatically by a computer, if the idle is high there is a problem with the system.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
