Questions & Answers for: Pontiac Montana cross fire exe

Question about 2001 Montana

1 Answer

Wires Crossed Pulled spark Plug wires and now I think they are not correct when put back on. What is the firing order for the front side of spark plugs? firing order

Ad

Question about 1999 Montana

1 Answer

Firing order What is the correct engine firing order for 1999 pontiac montana? Hello oluwolesegun: I am Roger and i can help. Firing order on this engine is 1-2-3-4-5-6. Please see the attached ...

Ad

I just replaced plugs and wires on the vehicle and now have rough idle and idle vacuum is steady at 15 inches in Michigan (no altitude). I tried spraying carb cleaner around hoping I would see a jump ...

show me the firing order and cyl numbers for a 2000 pontiac monta what is the firing order and cylinder layout for 2000 pont. montatna 3.4 1-2-3-4-5-6 Check the visual aid below to confirm.

i need to jump start my battery in a 2003 Pontiac Montana. Where is it located? the battery will be on the passenger side front of the engine compartment. It is under the fuse block and cross bar.

...is located just below, toward the headlight. It bolts to the body of the vehicle. Third remove the cross brace. This is the black pipe looking object going diagonal across the top of the battery

Question about 2004 Montana

1 Answer

I need to replace the battery in my 2004 Pontiac Montana. It is mounted under a cross brace and the under hood fuse panel. Help Please!! remove and reposition the underhood electrical center (fuse ...

Question about 1999 Montana

1 Answer

my fire order was342 and back side 561 is this even an order because i am sure it was No that is not the correct firing order of the 3.4L V6. Here is the correct diagram of the cylinders and the ...

Question about 2000 Montana

1 Answer

2000 pontaic montana wont spark likely a bad crank sensor or bad ignition module, coil packs can go bad to but not normally all three at the same time.if the coil packs look ok then i would look at ...

Question about 2000 Montana

1 Answer

won t start 2002 Pontiac Montana Day 1. 1.Changed the spark plugs and air filter. Cleaned the MAF sensor with MAF cleaner. 2.At first start the engine attempted to start and then back fired. 3.Tried ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...