Crankshaft pulley (vibration damper) moved forward. My son was driving my 1993 Jeep Grand Cherokee this morning and the serpentine belt came off. I installed a new belt and it came off immediately ...
...Crankshaft vibration damper pulley? Ya know, the one near the marks for checking the timing with a timing light? next time i repair a jeep i will have a look at the one on the front .personally i ...
...vibration damper may be going bad! It sounds like a belt problem....but isnt load sensitive right? Yeah....that's what they sound like. Especially the part where they squeal on start up. Have the ...
crankshaft keyway, install the vibration damper, washer and bolt. Lubricate and tighten the bolt to 108 N.m (80 ft. lbs.) torque. Install the serpentine drive belt and tighten to the specified tension
run across the pulleys of the engine, this causes the belt to make noise as it rubs on the edge. Many times this is causes by the crankshaft vibration damper coming part and the pulley walking outward
Question about 1996 Grand Cherokee
vibration damper that needs changing for a 1995 Cherokee Grand It wobbles so it needs replacing, what will happen if I continue to drive it this way ? And replacing it, is it as easy as just unbolting
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions