Questions & Answers for: crankshaft sensor 2001 aurora

...crankshaft postion sensor(S) It is best to have them both replace. After replacement, a "crank position variance re-learn" procedure will need to be done to relearn the new sensors. This will need to ...

...crankshaft sensor in.Now it wont start. It ran for a second and now it wont. It turns over well has lots of spark. we can not do the relearn procedure because it wont run.Fuel pressure is over 40 ...

...fuel pressure. 4) Crankshaft position sensor, but this will throw a code, so you should have seen this from step 1. 5) Spark plugs & ignition modules - should also throw codes. 6) Fuel ...

...jumps 2 800 after hesitating I'm going to bet that the Crankshaft position sensor is bad. The sensor has two sensors in it actually, that's why your still driving instead of on the side of the

where is the crankshaft sensor located on a 2001oldsmobile aurora 2001 Oldsmobile Aurora 3.5 Liter Crankshaft Position Sensor (CKP) Location Hope this help (remember comment and rated this).

...crankshaft sensor The Crank-Shaft Position sensor is bad. If you are not noticing any problems driving (engine dying for a second or stalling) you could reset the code and see if it appears again. ...

...CRANK SHAFT SENSOR B CIRCUIT, P1372 CYLINDER 5 MISFIRE, P1372 INGNITION SYSTEM OR MISFIRE, AND P0385 SENSOR B CIRCUIT MALFUCTION. What do i do from here? SOUND LIKE FAULT IN THE CRANKSHAFT

...p0385 Crankshaft Position (CKP) Sensor B Circuit p0386 Crankshaft Position Sensor B Circuit Range/Performance Make sure your crankshaft sensor is plugged in or replace the sensor if the plug is

...crankshaft. This combined with a speed sensor and and and the BAP sensor (Barometric Absolute Pressure) Gives the computer enough info to calculate the ignition timing. Not such a terror after having ...

how many crankshaft sensors are on a 2001 Oldsmobile aurora 3.5L ? I know of 1 behind starter, I've read a lot n there's a lot of reference's to more than one. Just that one. Pain to change.