...reaches below 1/4 tank and car is stopped when is restarted it begins to lurch and backfire. the crankshaft sensor was the only thing that came up on the computer. any ideas? THE CRANKSHAFT SENSOR ...
...engine to rotate during this procedure. Turn engine to rquired position using a spanner on the crankshaft pulley only. download procedure from my website... http://arraw.info/pdf/Timing ...
DTC code 0336 my outback 2.5 liter has code 0336 i replaced the Crankshaft sensor that didnt fix problem. Problem is engine cugs between 2,000 and 3,000rpms and will not run steady at concistant rpm. ...
...the A/C compressor drive belt tensioner. Timing belt & cover DOHC exploded view Remove the crankshaft pulley. Remove the mounting bolts and left timing belt cover. Remove the mounting bolts ...
piston slap It can be due to a wearing off of the crankshaft, possible fault or damage to the small end or big end bearings of the piston connecting rod. ALso the timing must be checked to be in order
How to remove crankshaft pulley to access timing belt on a 2003 subru forester hi it should be a 22mm bolt and best way is to put the car in 4th gear or drive if auto and get someone to jump on the ...
Question about 1997 Outback
...the ORDER correct, but the STARTING POINT off by one plug! If you can find the timing mark on the crankshaft, place it in line with the timing indicator, and that should make the rotor (under the ...
Question about 2001 Outback
...stalled in traffic and would not restart until popped the hood and slammed it back down. Could be crankshaft sensor,I had the same problem no code.when i replace sensor was
CRANKSHAFT FRONT BOLT TORQUE FOR EJ253 ENGINE should be in the service manual
...should I use to tighten the bolt that holds on the harmonic balance B: INSTALLATION 1) Install the crankshaft pulley. 2) Install the pulley bolt. To lock the crankshaft, use ST. ST 499977400 ...
Usually answered in minutes!
315 Questions
235 Questions
240 Questions
223 Questions
176 Questions