Questions & Answers for: Subaru crankshaft

crankshaft pulley i have a 96 Subaru Legacy. I've just changed the crankshaft pulley. is there a certain torque setting for the bolt? actually there is but mechanics always tie that bolt with an air ...

...time all marks align at noon,both lines on camshafts point up ,don't follow any marks on face of crankshaft gear follow line located on reluctor this is part of the crankshaft gear on back of it, ...

...out from behind timing belt cover, what can i expect? you have to replace the seal on front of crankshaft before it gets worse replace seals on camshafts as well, Oil pump housing should be ...

broken harmonic key in a subaru? KEY WAY ON CRANKSHAFT BROKEN.CRANK SHAFT HAS TO BE REPLACED.BECAUSE KEY KEEP BALANCER FROM SPINNING ON CRANKSHAFT.

DTC code 0336 my outback 2.5 liter has code 0336 i replaced the Crankshaft sensor that didnt fix problem. Problem is engine cugs between 2,000 and 3,000rpms and will not run steady at concistant rpm. ...

when the crankshaft timing mark is lined up on an ej20 subaru motor should the keyway be facing upwards? the one i am working on faces downwards and when i put the crankshaft/drive belt pulley on the ...

1993 SUBARU LEGACY CRANKSHAFT PULLEY IS OF BEFORE FINDING TOP DEAD CENTER WHAT MUST I DO TO PROPERLY INSTALL THE CRANKSHAFT PULLEY IN RIGHT POSITION AND DOES THIS PULLEY GET A KEY STOCK INTO THE SLO ...

how to test crankshaft sensor What should the resistance be between the tow terminals on the crankshaft sensor Hi Ron, Connect the two cables to an analogue voltage test meter. Turn on the mili ...

...on the harmonic balance on a 1996 subaru legacy outback From FSM: B: INSTALLATION 1) Install the crankshaft pulley. 2) Install the pulley bolt. To lock the crankshaft, use ST. ST 499977400 ...

...should I use to tighten the bolt that holds on the harmonic balance B: INSTALLATION 1) Install the crankshaft pulley. 2) Install the pulley bolt. To lock the crankshaft, use ST. ST 499977400 ...