Questions & Answers for: Mitsubishi Montero cranks but no spark

cranks over, no spark,no injector signal from ecu and fuel pump not working, all fuses are OK, truck shut off while driving. difficult one could be a multitude of problems from a supply problem to the

Ad

1995 montero 3.0 no spark on coil #3 I have a 1995 montero 3.0 vehicle would not start . It had no spark and intermittent spark. I had the ECM rebuilt and still the same problem. I replaced the crank ...

Ad

1989 Mistubishi Montero with rebuilt engine won't start. 1989 Mistubishi Montero with rebuilt engine, turns over but does not start. Timing marks are all set on crank, cams and oil pump. You'll lneed ...

Question about 1992 Montero

1 Answer

location of crank shaft censor Assuming a 3.0 V6; the crank sensor is actually located in the distributor. The 3.0 V6 makes use of small LED lights and a spinning disc located in the distributor. This

my Mitsubishi Chariot won't start after been drove and parked overnight engine cranking over but not start getting spark from the coils, getting fuel, all fuse good. REPLACE THE CRANK POSITION SENSOR.

Question about 1998 Montero

1 Answer

...cranks, but no spark,I already check all the spark plug,and also cannot synchronize to ECU,I also change the ECU but still the same,I even check the crankshaft sensor and all the wiring w/ test light ...

I have a 2004 Mitsubishi Montero that has been sitting for 2 months, it started perfectly and strong 2 months ago, the original battery was dead when we started it so we jumped it that 2 months ago, I

Question about 1990 Montero

1 Answer

No spark gives one spark when first cranking over then none after that. spark plugs wire,coils or cap,

cranks but no spark any solutions Mitsubishi Pajero Model GDI V6 3500,There's power, it cranks, but no spark,I already check all the spark plug,and also cannot synchronize to ECU,I also change the

2001 Mitsubishi montero sport xls replaced crankshaft sensor still will not crank Replaced crankshaft sensor, then had cyl 1 misfire replaced plug and wire it started but still misfired and then shut ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...