...last cold snap. First below zero day it started and ran just fine.....second day would not start. cranked slowly then clicking sound. Replaced battery and now cranks but will not start. Have tried ...
pt cruiser will not start until after it sits Pt cruiser will not start sometimes, but will crank aftrer it sits a while Are you saying it won't crank, or won't start ?
car till it wont start up again; unplug the crank position sensor and count to 5 then plug it back in. If it starts then its the crank sensor.(just a quick way to test it and get you home or to a shop
Question about 2001 PT Cruiser
...not start If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves when cranking the engine-if it does not, install a crank
Question about 2002 PT Cruiser
...crank and its still will not start it cranks but wont start? its like the coil is getting fire but not sending out fire anybody have a clue what this can be? Need to clear codes and re flash emc ...
Question about 2002 PT Cruiser
start,replaced coil,cam and crank sensors. What next??? so, i guess, you never seen a scan tool> you crank engine and you get DTC errors telling you what failed? crank for 5 seconds, bingo????? now
Question about 2004 PT Cruiser
...crank, but not start or will it not crank? If not cranking, test battery, clean post and check wires for corrosion and good contact. Also check the ground wire between the engine block and the car ...
Question about 2001 PT Cruiser
start. think the Map is bad? If you're getting a crank code, then change the crank position sensor..... Well dale this is what i suggest. I'll assume the car is cranking, and you have the right key. I
Question about 2002 PT Cruiser
,then this is referred to as a no crank - no start . There are very different diagnostic steps for each of these conditions . Your best bet is to have your vehicle diagnosed by a qualified technician
Question about 2002 PT Cruiser
what would cause a 2000 pt cruiser to turn over but not crank turning over is cranking are you asking why is it cranking but nor starting to get that answer , run the fault codes
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions