Questions & Answers for: crank shaft sensor location 97

...97 z71 vortec 5.7 replaced fuel pump.getting fuel and fire but won't start The # 5 cylinder is miss firing. not getting fuel. Could the injector just be stopped or the crankshaft sensor in gone. try ...

crank shaft sensor, and cam shaft sensor. Your going to have to replace the transmission with an older transmission like the turbo 350 or turbo 400. When it's time to get the car e-tested, that's when

...chevy z71 4x4 pickup i have no spark and a cod p1361. new relutor cranks sensor and still no spark whats the problem PO 1361 ignition control circuit low voltage. Check your ignition module and

...chevy Z71 and it will not start. all my fuses are working and so is my fuel pump. When i turn the key on none of my guage lights come on and when i crank it all it does is keep turning over, never ...

...shaft position sensor and it is running rough...i know i timed it right ...it was top dead center...any suggestions The timing cant be adjusted, you will need a scan tool to set Cam ****** Offset. it ...

...350 i replaced coil,cam shaft sensor,crank shaft sensor,and control module for the coil and the coil still wont fire but the plug going to the coil has fire to it..what else is left to change Bad ...

...crank shaft sensor, rotor and cap, new plugs, checked plug and coil wires they are good firing order is correct, h at my wits end here plugs seem wet after trying to start with my scan tool hooked up ...

...97 chevy ext cab z71 350 vortec 4l60e tranny shifts fine from 1st to 2nd and from 2nd to third but when the overdrive tries to engage it slips and my engine revs up but no accelaration. can anyone ...

crank shaft sensor location on 95 lexus sc300 please help Images for Where is crankshaft sensor location on 95 ... eplaced engine on '97 SC300 now new engine does not have Crank ... www.clublexus.com/

Crank but no start....... I've replaced fuel pump, fuel filter, brand new battery, coil, and passlock sensor and still will not start 2001 Chevy Tahoe 4x4 Z71 5.3 vortec did you have the passlock unit