Questions & Answers for: crank settings

Question about (T307S) Clock Radio

1996 ford ranger 2.3L 8 plugs single overheadcam

1996 ford ranger 2.3L 8 plugs single overheadcam need to know how to find TDC on crankshaft in the proper firing order to put timing belt on ...bought with out timing belt on l think the crankshaft ...

Question about 1996 Contour

6 Answers

Timing marks

timing marks i need the timing marks for the crank this is for the crank pulley timing marks ..... Disconnect the negative cable from your battery so the car doesn't start. Now, since you cannot find ...

Question about 1995 Accord

1 Answer

Set timing

set timing what way all pulley marks line up to, camshaft,crank,etc. set timing on 95 honda accord 4 cyclr. v teck or single, single cam says up on it crank has 2 b on combustion duall cams r facuing ...

Question about 1999 Intrigue

1 Answer

I have a spun rod bearing, and a scored crank

I have a spun rod bearing, and a scored crank I have a spun rod bearing, and a crank replacement -- along with full set of bearings -- is going to have to happen. Unable to locate crank or bearings ...

Question about 1989 Ranger

1 Answer

Dont know how to set

...ford ranger, first you need a timing lite second when you start it you hold the timing lite at the crank there are degree marks near the crank you should clean the crank and there is a mark on it ...

Question about 1998 Escort

1 Answer

Crank positioning for new timeing belt on a 2.0

crank positioning for new timeing belt on a 2.0 dohc crank on tdc / number one cylinder all the way up /balancer mark will be on 0 degree'sturn cam shaft till nuber one cylinder will be closed (both ...

Question about 1998 SL

1 Answer

Getting no spark. a recent code mentioned the

getting no spark. a recent code mentioned the crank sensor and o2 sensor. the o2 sensor was replaced and no new code has shown but it only ran once since then. would like to know where the crank ...

Question about 1998 SL

1 Answer

I installed a new Crank-shaft position sensor and Timing-belt, and now it won't start... I rechecked the cam and crank settings for the timing belt, but still nothing... Any suggestions?

...crank settings for the timing belt, but still nothing... Any suggestions? I just replaced the crank-sensor and timing-belt (also water-pump, balancer-belt while I was there)... Now it won't ...

Question about 2000 S40

2 Answers

2000 volvo s40 p0335 and p0336 intermittently

2000 volvo s40 p0335 and p0336 intermittently cranks slowly sometimes long crank time sometimes does not always set codes p0335 sets most commonly and p0336 once in a while codes only produce when ...

Question about 2000 S40

1 Answer

Crank shaft mark for fitting timing belt

crank shaft mark for fitting timing belt i don't know how to set/replace timing belt marks on crank shaft Try this may be this could help https://big-manuals.com You must set cylinder # 1( firing ...