Questions & Answers for: Jeep Grand Cherokee crank sensor

...CRANK SENSOR DISRUPTING COMMUNICATION WITH PCM. UNPLUG THE CRANK SENSOR AND CHECK FOR RESPONSE OF PCM. IF COMMUNICATION IS NOW POSSIBLE YOU HAVE A BAD CRANK SENSOR. IT'S A PROBLEM I'VE SEEN NUMEROUS ...

...crank sensor, crank sensor turn on the fuel pump as long the engine continue turning over. what crank sensor does it sense the crank/flywheel turning and it send single to the computer than computer ...

crank sensor wiring first. If the crank sensor wiring is good and not frayed or broken, replace the crank sensor. The crank sensor tells the fuel injectors and the spark plugs what to do. It's located

...crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of the bell-housing and usually on the drivers side. Dis-connect the faulty crank angle sensor and ...

...crank sensor defunct,or the Ecu packed up,if you change the crank sensor and see what happens then if need be make another posting ,also check the wires to the crank sensor for a dodgy connection and ...

...More than likely needs a crank sensor, Try cranking with the crank sensor disconnected, you should not get the dashes in the cluster. The crank sensors take out the communication system of the ...

...crank position sensor is mounted to the transmission bell housing at the left rear side of the engine block. Left is drivers side. If you have a 4.7 the crank position sensor is mounted into the ...

...Crank Sensor. I will bet money that if you replace the crank sensor it will solve your problem. BUT...Also know that a bad fuel pump can do exactly what you describe in your statement. Once the pump ...

crank sensor code. If you have a 4.0 liter replace the crank sensor adn you should be good to go. It is possible that you may also need to replace the distributor sensor but I wouldn't worry about

crank sensor location no rpm signal / looking for crank sensor location Does it run? if so then the problem is not the crank sensor which is located above the starter motor in the tranasmission bell ...