...thanks for your time and input. The crank and or the cam sensor has failed. If you have no way of pulling codes or checking for signals from the sensors, start with the crank sensor, its more
Where is tha crank sensor on a 97 lhs? The crank sensor is located under hood, lower driver's side of engine, mounted on the cylinder block. Hope this helped and best wishes.
1996 Chrysler LHS - Diagnostic code reads ''intermittent power to CMP and CKP'' what does that mean? it is losing the signal from the crank or cam sensors, a sign of a crank sensor failing.
crank shaft sensor and do not know where its located The crank shaft sensor is located on the front of the engine under the timing cover. In order to replace it you will need to remove the timing belt
...CHANGING SENSORS,FEUL PUMP,COIL PACKS AND COMPUTER BOXES,JUST WONT START?ANY IDEA? If it is cranking with out turning over I would check the fuel pump and ignition relay, crank and cam
crank sensor on a 1999 LHS? The crank sensor is located in the transmission bell housing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. One 10
...rpm input--circuit malfunction=== causes --wiring--CKP (Crank position )/ rpm sensor--ECM ---TCM-- depending on how your car is acting up will depend on if it is the TCM or the crank position ...
sensor? or Crank sensor? I know that the generic definition of DTC P0340 is "No cam signal at PCM" however, a crank sensor can also be the cause of this code. A cam sensor normally will not cause a no
sensor,crank sensor and coil packs. Probably the ASD relay. Try testing the car with remote star from the starer straight from bottom to top with out cranking from key i think you
Question about 1995 LHS
...until resently. the engine turns over strongly. there doesnt seem to be any spark because starter fluid gets no reaction. what is this most likely to be? Crank sensor a good possibility. Any
Usually answered in minutes!
229 Questions
216 Questions
228 Questions
195 Questions
145 Questions