Questions & Answers for: Pontiac crank sensor

...crank sensor malfunction To test this code, have a visual inspection of the location and wirings of the crank sensor. If the engine has a cam sensor, you might mistook it as the crank sensor (it is a ...

Ad

Question about 1999 Grand Am GT

1 Answer

...crank sensor, replaced #3 coil module, replaces ecm, continues to burn out crank sensor. came in with no start condition. after changing crank sensor threw #3 misfire code, replace coil which was ...

Ad

Question about 1995 Trans Sport

1 Answer

crank sensor 1995 trans sport 3.1 there is no crank sensor on 3.1, only 3800. I found that out while checking myself. However if you are having a cranking problem there is a fusible link that hooks to

...if no signal that look at the crank sensor. crank sensor will give you a no spark, so will an ignition control module, the crank sensor is by the crank pulley, the control module is under your

...sure this is what your problem is. After it gets hot and cuts off and won't start, try pouring or spraying water on the crank sensor then see if it will crank. You may have another bad crank

Question about 2004 Grand Am

1 Answer

...crank sensor.If it cranks but won't start, it could be a long list of things including the crank sensor.No crank could be the starter, neutral safety switch, key switch, or connection in the ...

crank sensor on a 3.4l 2003 pontiac grand am Will the crank pulley have to be pulled in order to get to the sensor? If you need to replace that sensor than yes you need to pull the crank pulley. There

...crank sensor grand am 2001 2.4 it cranks but dont start, i change cam and crank sensors and keeps giving me, camshaft failure code, some times it start but inmediatly turns off engine, when start, ...

Question about 1996 Grand Am

1 Answer

crank sensor will a bad crank cause a car to crank by not start a faulty crank position sensor will do that along with a faulty cam shaft position sensor along with an immobiliser not getting the ...

...sit on top of ignition module.You have two crank sensors, if crank sensor issue, check the 7x crank sensor, on back side of engine block, down low, two wire connector, wire colors, yellow and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...