Questions & Answers for: crank pully

crank pully that aligns with a tab on engine just above crank pully looks like a triangle with the tip near crank pully is rounded off. SOHC engines have an arrow on cam pully that aligns with a point

Ad

Question about 1991 Riviera

1 Answer

...as the 3800 The crank sensor is behind the Harmonic balancer / Crank pully. Special tool required to remove pully without damageing it. once pully is off the crank sensor is held inplace by 2

Ad

Question about 1997 Tracker 2 Door

1 Answer

Crank Pully: 1. Crank Pully Bolt 2. Crank Pully 3. Center Bolt 4. 5mm Hex drive (used to remove pully bolts) Once the fan stuff, and pully(s) are removed, then you need to remove the Timing Belt cover

...crank pully as its the crank pully that turns the belt, the crank pully is the pully at the bottom of the engine normaly the biggest check 2 see if the pullys bearings are working,just remove it and ...

Question about 1999 Ranger SuperCab

1 Answer

...crank shaft pully (for TDC). It is a line, scribed on the pully, that alligns to a pointer on the plastic timing belt cover. The second is on the cam shaft pully. It can be accessed by removing the ...

...crank pully and cam sprocket pully (biggest pullys) on both sides of engine all of these three pullies have notches on them that should be pointing at 12 oclock before belt installation. once you're ...

Question about 1993 Festiva

1 Answer

...crank pully and the bolts on the smaller pully and the warer pump pully put jack under oil pan, remove front upper engine mount and lower the jack this will allow you to remove the timing belt cover ...

...a 06 suzuki verona dohc v-6 should be in crank pulley. not in crank pully, beside crank pully mounted in the block with ione bolt and a wire harness. its the closest thing to the crank pully with ...

Question about 1995 Pajero 1.1

1 Answer

...crank pully is a two piece pully. The inner part is connected to the crank via key way, the outter piece, which runs all the drive belts is rubber mounted to the inner part. Check the center of the ...

Question about 1995 Pajero 1.1

1 Answer

can now mark( with tire chalk) the crank pully at 12 o’clock, and timing belt pully and adjuster. Make sure these marks are aligned when installing the new belt, using 24 mm socket on crank pully bolt

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...