Questions & Answers for: craftsman gas hedge trimmer start

Craftsman gas hedge trimmer Trimmer starts sometimes, then stops. Spark plug has been cleaned with fine sandpaper, gas oil mixture perfect (use craftsman two cycle oil). Does the carb need adjusting? ...

Craftsman Hedge Trimmer model 358.796353 that won't operate I have a Craftsman Hedge Trimmer model 358.796353 that was working fine for about 45 minutes. Then it died and would not start again. I let ...

...craftsman 22" hedge trimmer. Last year it ran great. Winterized it by emptying all gas. Replaced spark plug and put fresh gas mix in it. Ran for about 20 minutes and slowed down and stopped. I was ...

...gas, new plug. Ran fine for a couple of times. Now won't start, checked spark and there is none with the plug in. Take plug out check spark to ground and there is one. What do you think the problem ...

...have replaced plug and checked fuel supply but still no start if it sat for a long period of time the carb clogged with sheacked gas and the carb would need to be cleaned and rebiult. Have a great ...

trimmer starts and runs for 15 seconds and stops. won't start for a few minutes and does the same , Check the air filter, replace the fuel if it is last year's, clean the spark plug or replace. Also ...

craftsman hedge trimmer won't start. Trimmer quit running and I cvan't get it to start. Replaced spark plug. Cleaned air filter. Carbarator looks clean. Put fuel in cylinder. Does not fire. Nothing ...

...gas my hedge trimmer will not start... Put in new gas and mixed the oil properly... Sprayed quick start in carb...Will run for a few seconds then die... It's not getting gas, due to being gummed up ...

craftsman 358.796354 hedge trimmer that will start on full choke, throttle in the start position. But, as I move the choke from full it will rev up then stall. The only way I can get it to "r My local

hedge trimmer runs for a minute and cuts off. Will not start back up immediately. Change spark plug and cleaned carbureator Could be bad diafram pump on bottom of carb. Looks like a gasket with a ...