Questions & Answers for: Harley Davidson XL 883 Sportster cover removal

how do I check the fluid level in a 2007 harley 883 custom i changed the derby cover and some oil came out. is it filled with the same oil reservoir that is filled on the right side of the bike? No ..

Ad

Question about 2007 XL 883 Sportster

1 Answer

...on o6 sportster 883 low i need specific instructions on how to change this out... Remove battery cover on left side of the bike, remove the positive and negative cables and take out battery. It is ...

Ad

Question about 2004 XL 883 Sportster

1 Answer

...cover off gently and the transmission will come out of the engine cases. The shifter shaft will remain in the cases. When you reinstall the transmission, mark the shaft in such a manner that you can ...

I bought a primary cover and I don't have a manual to see how to take off the shifter lever to put the cover on There's a lot more to replacing the primary cover on a Sporty than simply removing the ...

Question about 2007 XL 883 Sportster

1 Answer

a lower bolt on the primary cover broke,so i removed the shifter and foot peg bracket,then removed all of the bolts from primary cover after draining primary fluid. The primary cover still doesnt seem

Question about 2007 XL 883 Sportster

1 Answer

...on 2002 sportster First disconnect the battery cable. Then you'll have to pull the primary cover off the engine. Find the primary case drain plug underneath the rear of the primary case and ...

...sportster? REMOVE SEAT, REMOVE 2 BOLTS KEEPING IGNITION IN PLACE. REMOVE UPPER BATTERY CASE COVER. REMOVE NEGATIVE TERMINAL FIRST TO PREVENT ARCING POSITIVE TERMINAL INTO FRAME SOMEWHERE. NEG ...

Question about 2007 XL 883 Sportster

1 Answer

derby cover change Does the gasket need to be replaced when I put on skull derby cover? Yes, you should replace the o-ring every time you remove the cover.

Question about 2007 XL 883 Sportster

1 Answer

shifter removal trans will not downshift Spring broken on shifter arm. Remove primary cover and inspect.

...the negative battery terminal or the ground cable to case connection and then remove the primary cover and then remove the two starter mounting bolts and washers with a ball hex driver. THEN

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...