spark plug boot puller.you need 3/8 ratchet wrench.spark plug sockets.from size 5/8 to 13/16.you probably need size 5/8 socket.you need extensions different sizes.and universal joints.to reach hard to
...spark plug and pull them off. Inspect the spark plug cavity to ensure there is no debris or dirt inside. If so, blow it out or vacuum it out. Place the spark plug socket onto the 12-inch long ...
...EXTENSION, YOU NEED SPARK PLUGS GAP GAUGE AND A 3/8 RATCHET WRENCH. YOU NEED A TORQUE WRENCH ITS NOT MANDATORT BUT JUST DONT OVER TIGHTEN SPARK PLUGS OR YOU WILL DAMAGE THE ALUMINUM HEAD
gap on sprak plugs for 2002 kia sportage SPARK PLUG GAP FOR 2002 KIA SPORTAGE GAP IS 0.039 - 0.043 .032
spark plug wires on the right plugs. I would also check to make sure they gave you the correct plugs and plug gap. Also check to see if the wires are connected or snapped to the plug, sometimes it's a
...correct pressure. Typically, base fuel pressure is in the neighborhood of 42 psi with the vacuum line disconnected from the pressure regulator. For spark, a quick test is to remove a plug, connect it ...
spark plug wire is, not completely snapped on, or the wire on the 4th cylinder was damaged when it was removed, i would start out making sure all the wires are on, you will either hear of feel a small
...spark plug and the gap should be 25th but some manufacturers specify a wider gap because they use a higher voltage spark than the old classic cars from my day but 25th is not far out for 99% of ...
Question about 2001 Sportage
...spark plug wires are on in correct firing order, as well as the spark plug gap. (spark plugs are not always gapped for the particular application from the factory due to the multiple array of ...
What is the gap needed for a 2010 Sportage 2.7 The spark plug gap? If you are using platinum or iridium plugs (recommended), do not measure the gap as you will damage the plug.
Usually answered in minutes!
1,074 Questions
1,058 Questions
918 Questions
753 Questions
343 Questions