spark plug keeps closing, it is on a 2 stroke 30cc grass strimmer. I will open the gap to correct setting but it wont even last to do one garden loss of power then stalls and wont restart until gap is
Question about 30 Cubic Centimeter Gas Brush Cutter
...Ryobi Brush Cutter. Replaced spark plug but still no spark. If the spark plug you have put in has the correct gap then u will next have to check or change the HT lead Change it if no spark is ...
...normal things spark plug HT lead on/off switch clean fuel Just a small hint the spark plug that the machine comes with is rubbish so if you havent please replace it and make shore the gap is ...
...spark plug - RZ7C. What is proper gap for plug?? thanks ront The correct gap according to my RY64400 operators manual is .025 and the torque is 170-190 inch lbs. The spark plug is NGK CMR7A or ...
Question about 30 Cubic Centimeter Curved Shaft Gas Trimmer
...correct to get spark. It is difficult to often see the spark due to the amount of plastic around the housing. Suggest spark plug tester (inexpensive) or do your best to ground it on the top of the ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...correct side out? They will only work 1 way, if installed with wrong side out... no spark. If the magnets will hold a regular sized screwdriver by the blade horizontally then they are OK. Measure the ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
What is th correct spark plug gap for a ryobi RLT26CDS 0.7mm gap
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
What is the correct spark plug gap for rcs5145b Ryobi chain saw The gap should be 0.5mm
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
CORRECT GAP FOR THE SPARK PLUG ON RYOBI BRUSH CUTTER MODEL RBCGM25SS .020" will do the job can be from .015 to .025" it will spark across that range if the coil is good If you have trouble starting it
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...sure your using a new spark plug gapped correctly Make sure also that ignition coil is gapped properly..by using a business card which should be to specs between the coil and magnets of y
Usually answered in minutes!
295 Questions
300 Questions
122 Questions
96 Questions
40 Questions