Questions & Answers for: corolla brake light stays

Corolla LE's brake lights stay on constently. Even when the car is off the lights stay on, and eventually runs the battery dead. could it be a fuse or break sensor? check the brake light switch on the

...Corolla Seca - hatchback. The tail lights and parking lights stay on even when the ignition is turned off and the key is removed. I have already replaced the fuse. If you put your foot on the brake, ...

...brake lights are staying on ; 1989 toyota corolla The positive or hot return wire for the brake light switch is now grounding out,brake light switch is now faulty or a short in the wiring is present ...

...Corolla LE brake light is on but no brake problems My 2008 Corolla LE has the brake light on. The fluid was a little low so I topped it off - the pads look good, the fluid is now full, the emergency ...

corolla brake warning light brake warning light comes on under hard acceleration and occasionally while braking. Brakes still have stopping power. Light normally turns off in under 5 seconds, seems to

...back(tail) lights stay on even when everything is switched off You probably have a stuck or misadjusted brake light switch. The brake light switch located under the dash next to the brake pedal

...brake lights stay on in 1990 toyota corolla IF YOU ARE SAYING THAT YOU HAVE REPLACED THE BRAKE SWITCH AND NOW THE BRAKE LIGHTS STAY ON THEN THE PROBLEM IS THAT YOU DID NOT SCREW THE BRAKE SWITCH IN ...

...corolla, 3rd brake light,tail light and stop lights stay on after i turn the other lights on. Your brake light switch is stuck. It is located under the dash, near the top of the brake pedal. Replace ...

...Corolla, I use the parking brake all the time - every time I park - and I've noticed the lights do not come on until I release the parking brake after starting the motor. When I park the car, until I ...

...OFF, IT IS A 93 COROLLA check to be sure the brake light switch under the dash on top of the brake pedal arm is disconnecting, see if unplugging that switch does the trick, if so , replace the ...