Questions & Answers for: cord rewind

rewind suddenly only takes up about 2/3rds of the cord. I tried pulling the cord all the way out to the extreme and rewinding again, but it looses spring power with about 2/3 left. May have to replace

...cord pulled out, the rewind spring should be very tight. The mechanism may just need lubricating, or there is a worn or broken part preventing the spring from retracting the cord, or the spring is ...

...cord in the rewind spring is off track and the spring and spool will need to be reset by opening the vac. If the cord will not budge either way , by now it has likely begun to twist and tangle.With ...

...rewind and reinstall the cord. When tying the knot ,make sure to use a light to melt the cord a little so the knot will not untie. Hold the handle tight and pull the screwdriver and slowly let the ...

...cord..It wont rewind but I can hear it trying to start It sounds like you did not properly rewind the spring that is behind the spool that the cord would around, that spring is what rewinds the cord ...

...rewind. The cord should be removed from the spool entirely, then wind the spool spring CCW for a number of turns making sure the spool can be turned for about 6 turns more (during start). Wedge the ...

...by Miele. There IS a fix to the cord rewind, unless your model falls within the 5 year warranty. In which case contact your nearest Miele dealer for a replacement to the cord rewinder. Good

...sure but if you can get into the rewinder you can free up the cord it should go, hope this helps. Chris there is a recall on this

...cord rewind mechanism, untie the cord's knot in the center of the mechanism and remove the old cord by unwinding it from the pulley. Thread the new cord through the hole it goes through on the ...

how to rewind the power cord assemble? The only way to rewind the cord assembly is to take the cord real out of the vacuum and rewind it and put it back in. There is no easy way to do it