Question about Blowers Rake and Vac - Electric Blower/Vac - 51573
...too. Unfortunately Toro does not provide a replacement part. HOwever, perhaps the new designed cord will fit as a replacement, but I am unsure of this. When my plug melts completely I will try
...Cord Replacement too loose! My self propell cord broke and I bought the replacement cord. I installed the new cord and all looks good, but when I pull the handle bar for the propeller to work, it ...
Question about Blowers Rake and Vac - Electric Blower/Vac - 51573
...cord, get rid of it. The over-heating is most likely from the brushes in the motor, which means, unless you are a licensed electrician or know one, the unit should be scrapped. Replacement parts for ...
Question about 51585 Power Sweep 7 Amp 2speed Electric Blower ()
...replacement, rewire it and you will be set to go. To eliminate the male cord and the female end of the extension cord you will use from pulling apart when in operation, just loop the female end cord ...
My lawnmower pull cord is stuck. I cannot start my mower. How do I fix this problem. Thanks! Need to replace pull cord
Question about Super Recycler Super Bagger Lawn Mower Rear Bagger 5
...to proper position. remove the cord assembly ,, either the cord is off track and needs to be rewound or it broke and needs
Question about Super Recycler Super Bagger Lawn Mower Rear Bagger 5
toro 6.5 recoil handle cord loose The cord from the recoil handle has come loose from the engine. Where do I put the recoil cord back at? I can't find where it goes? Should be on the outside ...
Question about Super Recycler Super Bagger Lawn Mower Rear Bagger 5
The post in the centre of the cup that holds the trimmer cord has melted slightly so that the cord no longer is released when tapped and even when the total "head' was removed i couldn't release any ...
broken starter cord what do I do to replace the broken cord with a new cord you have to remove blower housing(the part covering the engine) after first removing the plastic outer red cover.
Question about Power Clear 210R Part 38587
trying to replace a broken recoil starter and cord wont budge everything lined up properly but cord doesn't come out of housing to try and start blower Is the cord put in the recoil the right way. I ...
Usually answered in minutes!
370 Questions
122 Questions
62 Questions
64 Questions