Questions & Answers for: Panasonic cord replacement Irons

...and watch on multitester the resistance will change if nothing happen you have to change cord with new one. maybe your line cord is open or try to find the fuse inside the iron.

which wire goes where on the back of the iron. If no wiring diagram available, can someone take the cord reel off of theirs and see which wire goes where for me. Thanks Same issue i believe with metal

Panasonic Iron NI-R73NR will not heat up Either a bad thermostat or a bad heating element or an open connection somewhere in the power cord. My advice, toss it!

...THERMOSTAT and the THERMAL. That usually the problem w/ FLAT iRONS! Might as well check ur power cord too, it might have some internal cut wires in it, use ur multi tester to test the current ...

if you're dead.) Dump out any water that's in it. 2. Remove two phillips-head screws from bottom of cord winder at base of iron. 3. Pull cord winder housing away from iron to expose electrical wiring.

...be the problem if it is not heating up -- the problem could be a few things,, it could be a bad cord / connection ( at the iron side or at the plug side ),, it could be a bad switch ,, or it

...warming up any more what can i do? A. Check the wire connections. If so, tighteing or chaning the cord with do . B. Thermostat migh got suck, if so, inspection of it will show and you need to

I inherited a Panasonic cordless iron without a manual. How do I retract the power cord? I cannot locate a button for this. If you pull out the power cord 5 - 10 cm from the base, it should begin to ...

replace cord the cord has a break in the cover so it shorts out. I need to change the cord yes you can change it or you can also take some repair.

How can I repair my the retractable cord on my iron? The cord was pulled beyond it's point of being able to retract. Is there a way to repair this? Install a new one cuz that old one is compromised