Questions & Answers for: Craftsman cord reels

pull cord broke on my craftsman gas push edger. I replaced cord but when I pull cord..It wont rewind but I can hear it trying to start It sounds like you did not properly rewind the spring that is ...

Need to replace the pull cord assembly, because something that tension the spring is missing. Tried substitute cord but found after reassembly there was no tention on the cord something is missing. ...

How do I reload the trimmer line? Depending in model usually they sell a cartidge reel with line allready. If your handy savy! you may doit yourself. Turn your weed eater around make sure & ...

PULL CORD HOUSING IS REVITED TO ENGINE, CAN I DRILL OUT THE RIVETTES AND REPLACE THEM WITH SELF TAPING SCREWS? You could, but you shouldn't. I assume you need to replace the cord? Remove bolts from ...

how do I replace the pull cord on a craftsman 6.75 HP EZ walk? Remove the three or four bolts holding on the pull cover and lift it off the mower. Get a length of new pull cord and fish it into the ...

...I can not imagine how to put a put pull starter back on "wound tight". Your pulling on the cord tightens a spring which pulls the cord back in. They go back together with the cord fully

I need to replace a cord on an old Craftsman 1/2" drill I would like to find a cord with a rubber collar which fits into the trigger housing properly. Sears is no help. What to do? A diagram for ...

front wheels on manual mower lock when pushing for awhile. 1 Locate the height adjustment lever on the inside of the left rear wheel.2 Kneel next to the mower and push the left height adjustment lever

pull cord hard to pull and won't reel back in Brand new out of the box. I haven't even put gas in it yet. Pull cord is hard to pull and won't reel back in, I've put a ...

New the hose fitting for craftsman 580.752020 pressure washer I was replacing the power hose onto the reel and stripped the fitting coming from the pipe from the motor. I need replacement parts either