Questions & Answers for: Craftsman cord

...outlet has power You could have a couple of different problems. The first place to start is the cord. A quick and easy test to do is to crimp the cord in your hand while the saw is plugged in and ...

pull cord broke on my craftsman gas push edger. I replaced cord but when I pull cord..It wont rewind but I can hear it trying to start It sounds like you did not properly rewind the spring that is ...

Need to replace the pull cord assembly, because something that tension the spring is missing. Tried substitute cord but found after reassembly there was no tention on the cord something is missing. ...

how do I replace the pull cord on a craftsman 6.75 HP EZ walk? Remove the three or four bolts holding on the pull cover and lift it off the mower. Get a length of new pull cord and fish it into the ...

...I can not imagine how to put a put pull starter back on "wound tight". Your pulling on the cord tightens a spring which pulls the cord back in. They go back together with the cord fully

I need to replace a cord on an old Craftsman 1/2" drill I would like to find a cord with a rubber collar which fits into the trigger housing properly. Sears is no help. What to do? A diagram for ...

why does the speed flucuate on my trimmer? First, how long is your cord, and what gauge is it? Trimmers don't draw as much current as an electric mower, but they draw some, and if your cord is old, ...

How to replace the power cord? Ran over cord with lawn mower, need to replace cord Follow cord to where it goes on mower, then connect the wires the same way you took them off. but be sure to turn ...

I ran over the cord to the vac with my lawn mower ,I need to replace the damaged cord with a new one. How do I remove the old cord? You need to remove the screws that are in the location of where the ...

...to unscrew the starter assembly cover and remove it from the trimmer. Prepare the New Pull Cord: Cut off the old cord from both the pulley and the starter handle. Dispose of the old ...