Questions & Answers for: Asko cord

...of draining cycle and fault light would flash. this could be normally fixed by unpluging power cord, waitng for a few minutes and pluging power back again. wahat happened now is the different: ...

Asko dishwasher D1876 my dishwasher keeps overflowing, flooding my kitchen. unblock your filter. unplug all hoses and electrical cords. tip unit up and clean the filter out. should stop all your ...

can I change my WASHER cord to fit regular plug in You could but you need to be sure the voltage is the same. Then it it is the same you can a new cord with the right plug on it. You will have to take

...have a asko D3111 AND FOR NO REASON IT WILL NOT WORK I have checked power and that is fine. may be cord to machine going bad.check connection where cord ,or wiring connects to machineand check to

...available to the unit. This is part of a stacked set and the washer continues to run well. Power cord is plugged into the wall as well as the twi units are connected via the power cord. Does this ...

...a 3350 and it is not getting any water. i have found out that it is not getting power from the the cord that is going to the main el board. Do i need too change the main board ore could it be ...

My dryer's power cord has 4 prongs, my wall socket has 3 holes, can I change the power cord, or is there an adapter to change from 4 to 3 pronges. Un screw the 2 hex screws from the back of the dryer ...

...its hooked up to cold water...I just dont know what else to do. I did replace the 4 prong power cord with a 3 prong cord, if that makes a difference. This seems to be a fault with the controller ...

I have a Asko 7305 dryer,can I have a regular 240volt dryer cord put on it, so I can use existing wall receptacle ? I think you are asking if you can change the cord from 220 amp to 110 amp so you can

Asko Dishwasher D5636XXL how to hardwire,we can't find that connection ON THE DISHWASHER! Do we need to take apart the plug-in cord? The wiring connection is inside the machine for protection.