...nail and insert into the small gap between the battery and the main body to the left and below the copper colored sticker on the
Question about Bostitch Coil Framing Nailer
...copper wires. Some nailers have a different setting for the check paws on the latch door to compensate for the thinner nails (too much clearance between the latch door and body of gun). Check manual ...
...a bit cheaper than the entire starter. Usually, what you'll find inside is what looks like a giant copper roofing nail with no point on the shaft. The solenoid pushes the head against the copper ...
Question about NR83A2 2" To 3 1/4" Full Head Framer with Depth of Drive
nails to pass the driver i am using for ram otherwise the old driver will jam up also. To protect head and cylinder from damage I remove them and set to side. Place body of gun on soft wood and hammer
...nails unstuck Removing jambed driver can be very difficult. I use an old driver closely matching driver in the gun so that I know it will fit the nose. I grind the side of the used driver slightly to ...
Question about Factory-Reconditioned Porter-Cable FC350AR Clipped Head 2-Inch to 3-1/2-Inch Framing Nailer
...copper or brass hammer (caution, steel hammer may splinter metal, use protective gear ). You will need to strike very hard to remove some stuck nails. If first or second strike results in ...
...nails from rails. Use long piece of allen wrench or similar hard steel and grind the end to allow for jamed nail (I use a broken driver blade ground slightly thinner to allow for stuck nail). Use ...
Question about ZRR175RND FactoryReconditioned 134" Roofing Coil Nailer
...nails together is not too strong and stiff. Some coils have soft copper that works quite nicely and others use a stiff steel wire that tends to pull at the coil and leaves a stiff ...
...copper collored, however when tested with magnet is found to be metal), and after firing a few nails, open side door and check if the leading wire is not bending down. Leading wire will not allow the ...
Question about Coil Roofing Nailer
...the body is making full contact on the plywood. I use an old driver from framing nailer and a large copper or brass hammer (I have a 5 lb brass hammer). insert the old driver into the nose of the gun ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions