Questions & Answers for: Chevrolet HHR cools start remote replace battery

...remote battery but that did'nt fix the problem. They said there is a battery under the back seat that needs to be replaced. I've taken out the back seats but I still found no battery can someone put ...

...work? As long as your car is ready for remote starting, check your keyfob, as mine had a low battery and also cold solder joints which any electronics buff could solder for you to restore

...jump start on the UHFB there is a RED CAP that is your remote BATTERY POSITIVE on the LEFT STRUT TOWER THERE IS A REMOTE GROUND you can also find this information in your owners manual hope this ...

...remote didn't work, I used the key for entry and alarm went off.Took fuse for horn out to get home. Replaced battery in both remotes still don't work and can't set alarm because there is no way to ...

• Remote vehicle start The keyless entry system has the following components: • Keyless entry transmitters • Keyless entry antenna • 2 Way Advanced Remote Start RCDLR • BCM Guessing will not fix this

...remote start do not work the fob only works the panic button but the door lock button dose not work nor the start button and i have installe new battery in remote any help would be wonderfull I had ...

...other times it doesn't & i have to use the remote. I don't want to become reliant on the remote incase it's battery dies. Is there a way to over ried the remote? IF IT WAS ME, I CAN REPLACE THE

remote start stopped working remote start was working then just stopped working could be battery in remote or a system not allowing remote start because it detects a warning light on, jeep does this

...remote start has been added as it may have been disturbed during installation. You may want a pro to look at the system as it can be complicated to diagnose Sometimes this works: Seems like the blend ...

remote start receiver antenna located? Is it a piece of wire ? I recently replaced the front bumper cover and the driver's side front fender, since doing so, my remote start will only work from a very