LS coolant tank Hi Chad. My name is Kendall and I think I know what the problem is. My LS was leaking coolant in the same exact manner as yours and it ended up being a crack in my coolant tank. If you
...coolant container.car is overheating with less than 2 mins of driving Need to seal the leak in the coolant container with epoxy or by replacing the coolant container. Fill coolant system with 50/50 ...
container now have a old oil pan catching it...my question is with this much coolant in the oil what would be the problem cracked block,head gasket,cracked head,intake gasket,water pump, or oil cooler
Question about 2001 A6
...coolant container and when I arrived in front of my house after 10 mins of drive, it spilled all over the ground again. I then put stop leak in the container with coolant and followed instruction. ...
Question about 1993 SL2
coolant container is way low. I understand a radiator leak would cause the coolant to leak on the driver's side and that this could also be a hose or the plastic container is cracked. Feedback
...coolant container 1999 mercury mountaineer just starting leaking coolant but only when the engine is cool....I start off with s full radiator and plastic coolant container drive 45 min to work and no ...
container from the mounting bracket. Just be sure to do this while the engine is off and coolant cold. Check the tubes inside and out to assure no cracking or deterioration. If found defective replace
Question about 2002 Caprice
...transmission Have to use an exhaust gas analyzer at the exhaust tail pipe or coolant fill cap or over flow container You got a failed head gasket or worse, a crack that opens up whenever it wants ...
Question about 2002 Caprice
container, thermostat and the water pump has been replaced. the fan runs perfectly but the coolant still comes our from the radiator and the car overheat. limited info generic answer incorrect install
Question about 2002 Caprice
coolant overflow container and leak. From your description sounds like you have a blown head gasket or a cracked head either way you will need to pull the heads and have them checked by a machine shop
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions