...ICS with each other. Convergence still off (red bowed toward center on top and bottom. Now unable to access manual convergence with remote at all. Press it in menu and nothing happens. Checked ...
...problem picture bows up from bottom coloures out of line Good Day, harri1234; Sounds like a convergence problem. Convergence Output IC Failure Corrective Action: Replace the defective ...
Question about AV-48WP74 48" Rear Projection HDTV-Ready Television
menu but did not work. ? You need to replace STK ics which are convergence ICs in your tv You can get from the link below Click this link to get convergence IC It will cost you $20-30 to buy these IC
Question about GB4308 43" Rear Projection EDTV-Ready Television
...to replace convergence IC . YOu can get from the link below . Convergence ICs You need to replace both convergence ICs .It will cost you around $30 . The IC number is STK392-110 . Hope this helps
Question about VS-50705 50" Rear Projection Television
...to replace convergence IC . YOu can get from the link below . Convergence ICs You need to replace both convergence ICs .It will cost you around $30 . The IC number is STK392-110 . Hope this helps
Question about GB5108 51" Rear Projection EDTV-Ready Television
...ic's...still a converg on Apex GB5108 Replaced convergence ic's...still a converg problem this was the second set of ic's..please help did you replace the low ohm feed resistors with the
Question about PT-56WXF95 56" Rear Projection Television
...beeping sound, no front blinking. 100% Ur 2 STK convergence ICS are still dead.Ur ICS soldering some how,u got the ICS shorted.Or ur ICS not right kind of STK ICS,u replacing in ur convergence
convergence problem Usually what happens is that the convergence IC goes bad or the fuse going to the convergence ic goes bad. Pico fuses they are called sometimes open up. You may want to open it up ...
...Convergence ICs ,Big black ICs will have PN# on them example STK 392-110 Mats has ICs 1-800-628-1118 Tv have a problems known as a convergence problems,it is dead.The tv convergence board it is ...
...seeing double vision in different colors at all times If your tv is not a DLP the problem is in the convergence, try to adjust it using your original remote control go to the setting menu then to the ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions