Convergence Problems Set is approx. 5 years old. Red convergence was slightly off mostly in upper left corner a few months ago. Was unable to correct with remote and then it suddenly was back to ...
toshiba 40who8b convergeance problem picture bows up from bottom coloures out of line Good Day, harri1234; Sounds like a convergence problem. Convergence Output IC Failure Corrective Action: Replace ...
Question about AV-48WP74 48" Rear Projection HDTV-Ready Television
CLASS HD Convergance ploblem 43" CLASS rear projection tv the convergence has gone. i used the convergance setting in the menu but did not work. ? You need to replace STK ics which are convergence ICs
Question about GB4308 43" Rear Projection EDTV-Ready Television
my tv is showing a double picture in red You have convergence problem in your tv . You need to replace convergence IC . YOu can get from the link below . Convergence ICs You need to replace both ...
Question about VS-50705 50" Rear Projection Television
My Mitsubishi VS-50705 has an all over 3-D effect. Does it sound like the convergence? Yes it sounds to be convergence issue . You have convergence problem in your tv . You need to replace convergence
Question about GB5108 51" Rear Projection EDTV-Ready Television
Replaced convergence ic's...still a converg on Apex GB5108 Replaced convergence ic's...still a converg problem this was the second set of ic's..please help did you replace the low ohm feed resistors ...
Question about PT-56WXF95 56" Rear Projection Television
had convergence problem; replaced 2 stk392; panasonic pt56wxf95a : had convergence problem; replaced 2 stk392; resulted in bowed image; now tv shuts itself off after high beeping sound, no front ...
convergence problem Usually what happens is that the convergence IC goes bad or the fuse going to the convergence ic goes bad. Pico fuses they are called sometimes open up. You may want to open it up ...
...double picture and the colors are off. When trying to auto focus the blue lines are wavy. Replace Convergence ICs ,Big black ICs will have PN# on them example STK 392-110 Mats has ICs
colored lines at top and bottom when tv comes on and seeing double vision in different colors at all times If your tv is not a DLP the problem is in the convergence, try to adjust it using your ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions