Questions & Answers for: Nissan Quest control valve

...valve must be replaced as an assembly with the FIC solenoid. Fast Idle Control (FIC) Solenoid The fast idle control (FIC) solenoid (Figure 1) compensates for idle speed change caused by the operation ...

...control valve. I have played with everything but the Air control valve. I tried three different MAF, including a ghost sensor (circuit to match ressitance). I'm going to investigate the air idle ...

valve issue check the compression it need's to be!! 125 psi per cylinder Not familiar with that particular model, so check to see if it has an idle air control motor. Dirty or defective IAC will cause

No heat. A/C works. Engine temp normal. Blower works. Controls switch air flow properly. Inlet/Outlet heater hoses only warm. You have a valve that allows the hot water run to the heater core. Trace ...

where is the pcv valve located. and is it easy to change? pcv valve is on backside of engine. it screws in to engine behind idle air control. you will need a socket to remove it. have a good day !

...Valve Timing Control Solenoid Valve Circuit Bank 2Possible causes- Intake valve timing control solenoid valve bank 2 circuit is open or shorted.- Intake valve timing control solenoid valve bank 2 ...

...Valve Timing Control Solenoid Valve Circuit Bank 2Possible causes- Intake valve timing control solenoid valve bank 2 circuit is open or shorted.- Intake valve timing control solenoid valve bank 2 ...

...control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the ...

What is the IAC valve? My van dies when cold. After it warms up it run ok. I want to know the meaning of the IAC Idle Air Control valve -used to control engines idle

TELL ME WHAT IS WRONG.KNOCK SENSOR/SPARK PLUGS WERE CHANGED. Code 1105 is for a solenoid valve that controls the MAP sensor or Baro sensor. The solenoid valve would need to be tested