Questions & Answers for: Nissan Altima control valve

...Altima Heater contorl valve location Where is heater control valve located in 1995 Nissan Altima? HELLO THE HEATER CONTROL VALVE IS LOCATED AT THE REAR CENTER OF THE ENGINE COMPARTMENT BY THE ...

...valve timing control performance, There is a gap between angle of target and phase-control angle degree. Causes: - Harness or connectors (Intake valve timing control solenoid valve circuit is open or ...

...valve control. It responds to ON/OFF signals from the ECM. When the solenoid is off, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...

valve timing control solenoid valve circuit is open or shorted.) - Intake valve timing control solenoid valve may be faulty - Crankshaft position sensor (POS) may be faulty - Camshaft position sensor

...Control Valve Circuit P1445 EVAP Purge Volume Control Valve P1446 EVAP Canister Vent Valve Circuit P1447 EVAP Canister Purge Flow/Volume Control Valve Circuit P1448 EVAP Vent Control Valve Circuit ...

...Valve Timing Control Performance Bank 1 Symptoms - Engine Light ON (or Service Engine Soon Warning Light) - Possible engine lack/loss of power - Posssible engine rough idle Possible causes - Harness ...

...angle at the control position. Could be a problem with the control valve, oil flow to the valve, or one of the cam or crank sensors.Read more: ...

...valve control solenoid valve ? Accumulation of debris to the signal pick-up portion of the camshaft ? Timing chain installation ? Foreign matter caught in the oil groove for intake valve timing ...

...canister vent control valve - EVAP canister is saturated with water - EVAP control system pressure sensor and the circuit - Blocked rubber tube to EVAP canister vent control valve - Water ...

...control actuator B) Throttle valve opening angle in fail-safe mode is not in specified range. C) ECM detects the throttle valve is stuck open. Detected items Engine operating condition in fail-safe ...