Questions & Answers for: Nissan Maxima control panel removal

...control label Bad relay. They are to the right of the fuses (fuses inside the car). You can see the relays if you open the cover to the fuses (they are big blue cubes), but will need to remove a few ...

...control failed (see my post under 1994 maxima under gummydmilo - was a typo). My instrument panel failed. And the fan so I ended up replacing all the relays. If you remove the fan, you can hook it up ...

...and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the ...

...control plate and disconnect the electrical connections 4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel 5 insert a wide putty knife, a thin screwdriver ...

...control unit out of the dash remove outer panel, usually two screws above and snap clips below. When it's out of the way, the gauge cluster should be easily removed by then- usually two screws on ...

...and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can remove the bolts holding the mirror onto the ...

...pry it out. if not sections of the panel must be removed. to pry it out, use a screwdriver caefully. it's possible the control lever became detached and you may be able to snap it back in ...

control panel. thank your problem is usually the resistor, but switch may be going bad too. The resistor is next to the blower motor, above the passenger's feet. You may have to take the glove box out

where is the immobiliser? THE IMMOBILIZER CONTROL MODULE UNDER THE DASH NOT FAR FROM STEERING COLUMN.IF YOU REMOVE LOWER DASH PANELS IT WILL BE A LITTLE BLACK BOX WITH WIRES GOING TO THR STEERING ...

panel. There is a canister purge control valve and a canister volume control valve, so make sure you are dealing with the right valve.The volume control valve should be on or near the intake manifold,