Questions & Answers for: Ford Focus control panel removal

Question about 2002 SVT Focus

1 Answer

...panel. Disconnect the mirror control switch electrical connector. Disconnect the mirror electrical connector. Release the clip. Detach the electrical connector. Disconnect the electrical

Ad

Question about 2001 Focus

2 Answers

...control panel, underneath the radio, of a Ford Ka. Many thanks, René you can buy a pair of 2 prongs that fit into sides of panel and then you just pull it out. i was told halfords sell them for ...

Ad

...panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the ...

...control panel and disconnect the electrical modules. Set the panel aside. Remove the three panel-mounting screws on the lower portion of the door panel. Use the trim panel tool to help you pop the ...

...the heater control panel on a ford puma First take the stereo out.the there is two screws either side at the top of the control panel.Unscrew them and disconnect the wires and it should just come

...panel.Open the glove compartment.Remove the footwell vent air duct. Pull off the hose.Close the glove compartment.Vehicles with electronic automatic temperature control (EATC) built 11/2003 onwards ...

none others would work. Some vehicles it is not necessary to remove door panel when removing the master control switch. I'm not sure if you are one of the ones that doesn't have to do that.. good luck

Question about 2000 Focus

1 Answer

...control panel. Remove bezel with heater/air conditioning control panel .Remove the heater/air conditioning control panel from the bezel you will need this tool shown below to remove the factory ...

control panel. Let me know if you have questions. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection. Remove or disconnect the following: Audio unit

Question about 2001 Focus

2 Answers

...panel...The PCM (Power Train Control module)is bolted to its securing bracket...PCM is static sensitive, so make sure you have one hand on chassis ground before you touch it... ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,749 Questions

2001 Ford Focus
2001 Ford Focus

2,612 Questions

2003 Ford Focus
2003 Ford Focus

2,055 Questions

2005 Ford Focus
2005 Ford Focus

1,226 Questions

2004 Ford Focus
2004 Ford Focus

897 Questions

Manuals & User Guides

Loading...