Questions & Answers for: Ford F-150 control panel removal

Question about 1994 F150 Styleside Supercab

1 Answer

...control. On vehicles with power door locks, remove the power door lock switch housing. On models with electric outside rear view mirrors, remove the power mirror switch housing. Remove the retaining ...

Ad

Question about 2000 F150 Flareside SuperCab

2 Answers

panel. Disconnect the climate control wiring harness connector. Remove the audio unit. For additional information, refer to Section 415-01 . Remove the antenna lead-in cable from the instrument panel.

Ad

...control switch. Remove the door trim panel. Remove the door speaker. Remove the door watershield. NOTE Do not remove the window glass from the door. Remove the window glass from the window regulator. ...

...control switch electrical connectors 5W505424-S301Bolt 6W701930-S424Bolts (2 req'd) 719A034Water shield 8W709132-S300 (High series trim) / W709133-S300 (Low series trim)Speaker standoff (2 req'd) ...

...control panel on driver door. do I have to remove the door panel usually as the control panels are held in place but the door panel. try to sneak a peak of a repair manual somewhere or buy one as you ...

Question about 1999 F150 Regular Cab

1 Answer

...control panel out with the same flat head screw driver and disconnect all connectors. Remove small screw from behind it (6mm) 4. Lift straight up on door panel and then tilt toward you. 5. Disconnect ...

Question about 2001 F150 Styleside SuperCrew

1 Answer

control module (PCM) electrical connector. Remove the right front door scuff plate. Remove the right cowl side trim panel. Remove the clip and remove the PCM. To install, reverse the removal procedure

Question about 2001 F150 Styleside SuperCrew

1 Answer

...holding the HVAC panel on, and remove the bulbs from the back of the HVAC control panel. This is assuming the bulbs are the reason. Does the glove box, Ash Tray & Engine compartment lamps work

Question about 1997 F150 Regular Cab

5 Answers

...panel/floor door vacuum control motor. Disconnect the vacuum line connector. Remove the two panel/floor door vacuum control motor screws. Slide the rod out of the door and remove the panel/floor door ...

Question about 1997 F150 Regular Cab

3 Answers

...control panel. Check the connection to the intake manifold--it is usually a rubber hose stub that can get brittle and start leaking. If that is good trace the plastic hose into the truck and to the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Ford F150
2004 Ford F150

2,636 Questions

1990 Ford F150
1990 Ford F150

1,214 Questions

2005 Ford F-150
2005 Ford F-150

1,298 Questions

2006 Ford F-150
2006 Ford F-150

1,038 Questions

Manuals & User Guides

Loading...