...lock to signal the control board that the ?Lid Is Locked?. Can you select Spin only cycle and press the start button ? do both lid locks close and lock the lid? If they did and you still take ?FL? ...
try: 1.Check wire connections in harness leading from machine control board to door lock mechanism. 2.Check solenoid and door lock enable switch in door lock mechanism. 3.Replace responsible component
...control lock and wont let me do anything. The Control Lock is a safety feature that allows the consumer to lock the control panel to prevent children from manipulating the controls and accidentally ...
...control lock off The Control Lock is a safety feature that enables the consumer to lock the control panel to prevent children from manipulating the controls and accidentally starting the appliance. ...
...control lock) button continuously for 3-5 seconds. That should clear the lock.Now you can use the controls normally. To re-enable the control lock, press and hold the control lock button continuously ...
...to control board the door is locked. 1.Check wire connections in harness leading from machine control board to door lock mechanism.2.Check solenoid and door lock enable switch in door lock
Question about Neptune Washer
...Control Lock feature has been enabled, the Control Lock light will flash 3 times indicating that it is activated. To turn off Control Lock, press and hold the Options key that says "Control Lock Hold ...
Question about Neptune Washer
...control will sometimes lock because it "thinks" a clean cycle has been initiated, if replacing the control did not fix the lock icon, test the switch... Incorrect temp probe and thermostat failures ...
...Control Lock/Unlock" button on the control panel to unlock the control panel. The "Control Lock" status light goes out when the control panel is unlocked. Also try unplugging it for five minutes to ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions