Questions & Answers for: Electrolux control lock

...locked. tried reseting, tried all troublshooting areas, still locked out. can it be the main control board? Problem closing the doorDoor lock faultyWiring faultyMain board faultyCycle is paused ...

...lock control. It is design to prevent children from accidently change the dishwasher cycle or starting the dishwasher. It locks the dishwasher controls by pressing and releasing the DELAY TIME icon ...

...Control Lock, press and hold the heat dry key or press down on the lock icon for approximately twenty seconds. If issue persists, you may reset the dishwasher by either unplugging it or flipping the ...

control lock preventing the operation of the stove how to unlock the control lock Hi Bruce, this is AP! I understand you are struggling with the lock feature on your Electrolux duel fuel range, model ...

...control lock, and if you hold that button down for three to five second it should release the control panel. If that does not help release the panel I would suggest performing a reset and you can do ...

Lock control #3 on Electrolux slide in range Lock control #3 displayed and will not unlock. Tried turning off electricity and still will not unlock. I appreciate your post, Billy! I understand that ...

Control F1 - Door will not Lock Check door lock. Is Door Lock Getting Power F2 - Door will not Un-Lock Check door lock. Is Door Lock Getting Power Supply? Check Control Thermostat F3 - Self Test Error

...how to disable the control lock. You can locate the serial tag (which lists your model number) on the inside left hand wall of the dishwasher. With that information I can assist you further. ...

...lock and the control board. If the wiring is well seated and the wires have continuity, replace the door lock. If the replacement lock doesn't solve the problem, then replace the main control board. ...

...lock the control panel to prevent kids from activating the unit. To toggle lock/unlock mode, open the door, press and hold the AIR DRY button for 4 seconds. if lock isnt your problem then bad control ...