how to replace ball joints if they are the upper ball joints you may have to replace the whole upper control arm it will come withe a ball joint already installed.
...that shows a breakdown diagram of the mountaineer front suspension with control arms. chilton or hayes make a great book for your truck with pics diagrams and full instructions on how to do a tear ...
control arm with them Thanks Rob Try Autozone or Oreillys for the parts. If they list them you can do just the ball joints. I had the same story with my 2002 Mercury. The dealer parts guys told me the
would a split-bushing seized- control arm frozen cause it to act like it has no power steering? no it would not.
...Upper Ball JointRemoval & InstallationBall joints on this vehicle are an integral part of the control arm. If the ball joint is defective, the entire control arm must be replaced. --- Upper ...
...and if it bounces more than once they are worn, if not then it might be a different problem, like control arm bushings, or strut ...
...up and away from the lower ball joint. Unscrew the grease fitting from the bottom of the lower control arm. Press the lower ball joint out of the control arm using a ball joint remover set.
Question about 2004 Mountaineer
2004 mercury mountaineer suspension failure after install of new struts, would the lower control arm being to tight cause this to happen brand new struts, lower control arm not responding,now ...
Question about 2003 Mountaineer
4.0l 4wd. How can I remove and replace the left lower control arm? The lower ball joint is not tight. you pay a dealer or other type or repair shop do it not a DIY task as it had to be realigned after
Question about 2003 Mountaineer
I have removed all the parts but can't get the screws out from the lower control arm on 03 Mercury Mountaineer and advice would be appreciated put a nut on them and smack with a brass mallet they ...
Usually answered in minutes!
658 Questions
555 Questions
524 Questions
377 Questions
323 Questions