Questions & Answers for: Hyundai Santa Fe control arms

...control arms & reseated springs, also machined hand brake & serviced rear shoes. The noise seemed to be gone, but a week later the creeking noise returned every time I applied the brakes. Again I ...

Need instructions to replace 2007 Santa Fe side view mirrors On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on ...

...on the right front wheel assembly. It's the little electrical knob looking thing right behind the control

how to change the front lower ball joints? YOU MAY NEED TO REPLACE THE LOWER CONTROL ARM AND BALL JOINT AS AN ASSEMBLE. AFTER MARKET BALL JOINT ARE AVAILABLE BUT MOST LIKELY WON'T WORK. GO TO THE ...

...control arms to be disconnected and reconnected. If it was only "modified" there would have been no disassembly of the control arms required. See the picture below. The picture shows the rear ...

...a flat road without crown. I have same problem, turns out to be a worn/bad lower ball joint on the control arm.  Seems easiest solution is replace the entire lower control arm assembly -has

...1701 means: TPS signal to TCM malfunction. TPS=Throttle Position Sensor. TCM means=Transmission Control Module. The engine shake requires further diagnosing. Best advice is to take/tow the

Lower ball joint 2002 hyundi santa fe Typically these are replaced with a complete lower control arm. What happens is the ball joint is reseeding the lower control arm and rusts. When the old ones ...

...be? 1- front wheel bearing hub loose or loose axle nut 2- front shock(s) 3- ball joint(S) 4- lower control arm bushing(s) all of these things can be checked by a professional in about 15 minutes and ...

...gas. Have the front end inspected by a pro. Possible broken/loose sway bar link...motor mount... control arm bushing.... ball joint.... strut assembly Is it front wheel drive if so could be a CV ...