Questions & Answers for: Ford Thunderbird control arms

1997 ford thunderbird LX . Rear Wheels - Upper control arm bushings. The upper control arm bushings on rear wheels are beginning to wear(128,000 miles) . Dealership tells me that have to replace all ...

left front vibrates while driving on 97 thunderbird. is it the control arm bushing have you had the wheel balanced

WHEN REPLACING LOWER CONTROL ARM ARE THE BOLTS METRIC Yes, they are metric.

...The rods that connect the K-member (subframe) to the lower control arms are called "strut rods". Your local auto parts store should carry the bushings. they are called tie rod ends . inner and ...

can you show me detail pictures of step by step repair of ball joint and controll arm of 1990 ford thunderbird v6 3.1 automatc REMOVAL AND INSTALLATION Upper ball joints are not replaceable. The upper

...is needed to repair Look into it, but it could be a noise generated from the strut and not from the control arm (or A arm). If it is the control arm that is squeaking, the culprit will most likely be ...

...stud. Separate link studs from spindle and stabilizer bar using Joint Separator. Support lower control arm assembly with jack. Raise control arm with jack until stabilizer link can be separated ...

how to replace ball joints on 1996 thunderbird The upper ball joints are replaced with the entire control arm assembly. The lower ball joints are pressed in and out with the aid of a special press.

control arms on a 92 ford thunderbird. There are two bolts at the top of the arm that go through the bushings. These bolts have metal flags/tabs on them that need to be cut off. Can not figure out how

...brake after applying the brakes. i have changed on both sides of the car--- struts springs, lower control arm all bushings lower ball joints, wheel bearings hub kind rotors and brakes. Anyone know ...