Questions & Answers for: Ford Expedition control arms

...seperator with the hammer, this will pop it loose, then take a large crow bar and push down on the control arm, this will free it from the arm... use a drill with a 1/2" bit to drill the rivets out ...

...of possibilities here,if it is a "toe out" problem this could be caused by worn tie rod ends or control arm bushings but this may also be a camber problem however camber usually affects one ...

The wiper blade connection has released from the wiper blade motor bar that controls the wipers movement. You can hear the motor working but the arms have been disengaged. please rate as fixya if this

...control arms I have a 1998 Ford Expedition, 4 wheel dr. 4.6 liter engine. I'm trying to change the lower ball joints in the control arms. My question is, can you replace the ball joints seperate from ...

...control arms have to be replaced as a unit.Is this true? U CAN REPLACE JUST THE BALL JOINT OR THEY COME WITH THE ARMS.DEPENDING ON MECHANICAL ABILITY AND TOOLS IT IS MUCH SIMPLER TO REPLACE THE ...

...my 2000 ford expedition.I put an new thermastat in, and it still does not get hot. Check the heater control valve and see if it's operating properly. This should be on or close to the firewall behind ...

...stopped blowing out of the dash vents The direction of the air flow (dash/defrost/floor, etc) is controlled by vacuum going to the switch. There may be a vac line that didn't get connected or was ...

ford expedition, i want to know if i can purchase just the ball joint or do i have to buy the whole control arm assembly. and do you know how to take one apart... you can do it either way, but special

...control arms that attached to each front hub. There are hugh ball joint in each control arm, upper and lower on each of the Ford Exp. Two per side four all together. I hope this help you. ...

how to replace turn/wiper control -switch arm at steering if im right there should be a clip under them wich you pull out and the arm should slide out of there