Questions & Answers for: Daewoo control arms

1998 daewoo nubira power windows intermitently stop working switches ok suspect control relay, where is this located? relay for electrical windows is located underneath the arm rest in the drivers ...

...control arm Having trouble getting the contol arms back into place. Any tricks? MAKE SURE YOU HAVE WEIGHT OF VECHICLE RESTING ON JACK STANDS.PLACE JACK STANDS UNDER THE FRAME.THIS WILL TAKE PRESSURE ...

...I'm getting used to it but it isnt right.Tracking,a seal , ball joint or something? lower control arm. they last about 30k before needed

...control arms[upper/lower]shock sway bar,bushings,steering components-----jack up side where noise is coming from leave tire on -move tire up down and side to side -look and listen also if any oil ...

going to run off the road .it also eats the front tires, what could be wrong? Bearings, ball joints, struts, or it may just need a front end alignment The lower control arms (wishbones) need replacing

...in the car. You might be able to take a coathanger and manually open the door if you can get to the control arm. They are usually hard to get to and pretty expensive. It is located under the dash at ...

WHERE CAN I FIND A LOWER CONTROL ARM BUSHES IN THE EASTERN CAPE. HOW MUCH DOES IT COST. WHAT ARE THEIR CONTACT NUMBERS? Try (discountautoparts.com) if they have them they can give you the cost.

...control arms and the outer tie-rod ends and no problem now. Control arm bushings are known to be a chronic problem with these cars. A simple check: Jack one side of the car. The control arm is that ...

2003 daewoo makes a popping noise when coming to a stop from drivers side frontend check out lower control arm bushes rear bush moves was revised bush for this and check tie rod ends as well as ...

...control arms, then remove the front wheel remove ball joint and nut, remove steering knuckle from the lower ball joint using tool KM 507 B. remove control arm to crossmember nut and bolt, remove rear ...