Problem when i press the on button,the programme dial starts to rotate & continues to do so, without connecting to a programme. if left it will keep rotating round. appreciate any advice Set the ...
washing machine was running and stop inbetween rinse cycle and water pump got spoiled ihave already replaced with new pump but it is stuck on continuing programme and do not function at all. it only ...
...continue button but the programme will freeze.I will go crazy if this does not work for i need the programme for work. The message is below. An unhandled exception has occured in your application. If ...
Question about Programmable Thermostat Heater
Programmable thermostat intermittent problems... Our programmable thermostat works great, most of the time. Sometimes, however, the unit will not shut off once the thermostat reaches the programmed ...
sticking programme programme starts and during first phase just continues - water does not heat up Hi, This could be a problem with the controller as it is not waiting for water to warm before ...
Question about 24 in. ADP5966 Free-standing Dishwasher
...in for about 10 seconds, it should reset.(switch off then on again to push start.). If same action continues, the electronic module needs to be
Question about 24 in. ADP5966 Free-standing Dishwasher
...after main wash (seems to drain ok), found out if you put a jug of water in when it freezes, it continues the remaining part of first rinse and continues rest of auto programme fine (2nd rinse, ...
ideal classic se24ff The boiler has worked perfectly for 5 years and annually serviced.There is no certainty that the boiler switches off when the programmer requests such - I changed the programmer ...
Question about 24 in. ADP5966 Free-standing Dishwasher
...programme listing. I have scanned for channels, but it doesn't continue to the listings. The programmes can be viewed, but no guide and no recording allowed Can't answer without model number, if
Question about 24 in. ADP5966 Free-standing Dishwasher
the machine does not want to change any programme...stuck in one programme mode and not finishing programme...the time is continuous,,,no end to programme Most likely control board defective
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions