Questions & Answers for: connector 14

...14 pin connector to the motherboard. There is a pin in the back panel of the computer, so the back end of the power supply rotates when the end closest to the front lifts. 4. The 14 pin connector is ...

14-way connector. In most cases, the engine controller is mounted in the engine bay to the firewall or a fender. Some early models mount the engine controller in an air duct mounted on the inside left

...power LED (12+, 14-) ** only if power wire is 3 port connector ** 13-14 power LED (13+, 14-) ** only if power wire is 2 port connector ** 15-16 power button (15+, 16-) Did this solve your

...power LED (12+, 14-) ** only if power wire is 3 port connector ** 13-14 power LED (13+, 14-) ** only if power wire is 2 port connector ** 15-16 power button (15+, 16-) Did this solve your

P3 that leads into the control board/user interface. P3 is on the console. P1 is the connector that plugs into P3. P1-14 matches to P3-14 etc. There are exposed connectors on one side of the connector

...connector "B", terminal No. 14 and mainshaft speed sensor harness connector. If continuity is present, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary. If ...

...connector "B", terminal No. 14 and mainshaft speed sensor harness connector. If continuity is present, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary. If ...

Connector Wiring Color Code # Color Gage Circuit Function 1 white 10 common ground 2 blue 12 electric brake 3 green 14 tail/running lights 4 black 10 battery charge (+) 5 red 14 left turn/stop 6 brown

...14 NO - Go to Step 9 7 Inspect for poor connections at the harness connector of the IPC. Refer to and in Wiring Systems. Did you find and correct the condition? YES - Go to Step 14 NO - Go to Step 11 ...

...code 14. Description: Ignition signal Malfunction. Solution: - Check the distributor wiring and connectors for broken wire, looseness or scale in connectors. - Replace distributor