...and thermostat gasket for your car, then locate the upper radiator hose. Where the upper hose connects to the engine there should be a two bolt hose connection/ thermostat housing ( could be 3 ...
...connect to the G terminal at the thermostat. The Y1 wire(cooling) from your furnace you connect to the Y1 terminal at the thermostat. The C wire(common or neutral) from the furnace you connect to the ...
Question about Programmable Thermostat Heater
...Lux DMH110 digital thermostat. My furnace(oil) has only two wires on the thermostat(heat only). I connected the wires according to directions of new thermostat, but furnace will not start. Make
thermostat are positioned. Install the water inlet connection assembly retainers and tighten them to 71-106 inch lbs. (8-12 Nm). Connect the lower radiator hose to the water inlet connection. Fill the
thermostat are positioned. Install the water inlet connection assembly retainers and tighten them to 71-106 inch lbs. (8-12 Nm). Connect the lower radiator hose to the water inlet connection. Fill the
...thermostat, connect the yellow wire to Y, the white wire to W, the green wire to g, and the red wire to r. At the air handler, connect the thermostat wires: White to w1, yellow to Y, green to G, and ...
...the new thermostat on the mounting bracket. Be sure to tighten the screw enough to keep it secured. Connect the wiring to the thermostat and reinstall the screws to hold the wiring in
Question about Protectorelay Oil Burner Control R8184G4009, 45s. lock out
...connect the two thermostat wires from a Honeywell R8184G4009 to a programable thermostat. My old thermostat is not marked. Connected to a programable thermostat. --- ACE Smart Temp Universal ...
Question about Programmable Thermostat Heater
where is the thermostat on a 1995 buick regal? the upper radiator hose is connected to the thermostat. the thermostat is inside the shell that connects the shell to the hose. the upper radiator hose ...
Question about Programmable Thermostat Heater
...If it's there connect it to C on the thermostat and to C on the furnace. Remove any jumper from R to RC or from RH to RC depending on your thermostat and connect wires same as the old
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions