Questions & Answers for: Mackie how do i connect mixer and amp

...Mixer L/R ===> EQ Input L/R ==> Amp Input L/R ==> Speakers L/R Using insert cables you would have a single 1/4" connector at the mixer end (inserted in to the "insert" L or R) and the other ...

...connect from the mixer to your amps, preferably XLR connections. 2. Service the power to the amps and the mixer from the SAME place even if it means stringing a power cable alongside you audio cable ...

...Mixer. I connect the Power Amp to CFX12 (Main In) and speakers, connect the CD to CFX12 (Tape In). I did not get any sound. Please advise what was the problem for not getting any sound and how to ...

...connect it to the line in socket of the mixer ( not the XLR Mic in ). This will give a clean and flat sound which you will have to customize using the Mixer tone control and not the bass amp

...mixer and then balanced audio interconnects from the amp daisy chain inputs to the existing speaker inputs. If the amps do not have linked input jacks, then use TRS type WYE connectors at the inputs. ...

...mixer or what is the proper way to connect the monitors Without more information of your speakers and amps we can't really help you. The Mackie board puts out line-level signals and that should ...

...how you may wire your system. Please remember that compression, limiters and EQ device connect between the mixer and the amplifier with their prespective IN and OUT levels adjusted

mixer and so you must connect a power amp to the "line level" outputs of the mixer. Other "no output" problems could be related to buss assignments and other signal routing issues. Check for output by

...mixer to the amp the amp showing it clipping and no sound to the main speakers If you are getting signal from you mixer at leaves tha are clipping your amp, then the mixer is working and at least the ...

Mixer signals is on but qsc 1450 amp not giving any sound when main output is connected but when run aux send to amp it gives sound. What might be the problem. Mackie mixer 16 OK-qsc rmx 1450 main not